New Bumper Question

[Dave]

Alright folks,
Got this new bumper from Jay (thanks again)



now the question is, what mesh do i go for, i'm thinking black cos of the black bonnet, but there's two here on hostile performances site, narrow or wide!!

http://www.hostileperformance.co.uk/Pro ... tegory=570

any suggestions?

[CJ]

Go silver, if you don't like it, paint it black, simple!

CJ

[Dave]

point noted, wide or narrow though?

[kevinod]

The pics on the site are all the same, so hard to compare, but for a gap that big in the bumper I'd be inclined to go with the wide mesh I think...

[Dave]

yeah i'm thinking the same myself!!

whilst i'm getting gear from Hostile, anyone rate these??

(i don't have the original one in there cos that's where i'll be routing the intercooler pipe)

http://www.hostileperformance.co.uk/Pro ... vehicle=10

[Hostile Performance]

Hi Dave,
Just to let you know, we can also do another mesh which is cut to size - the shape is a 'square' diamond shape and is ideally suited to bigger front bumpers like this (I have it on my car as well).

It's very tough, high quality stainless steel mesh.

If you measure the amount you would need I could give you a quote for it.

HTH

Mike.

[Dave]

Hi Dave,
Just to let you know, we can also do another mesh which is cut to size - the shape is a 'square' diamond shape and is ideally suited to bigger front bumpers like this (I have it on my car as well).

It's very tough, high quality stainless steel mesh.

If you measure the amount you would need I could give you a quote for it.

HTH

Mike.

Cheers Mike,

It works out at 100Cms by 32.5Cms (allowing for some decent slack), i'll probably be going for the powertec 50MM cold air feed as well, so if you want to PM me a price for the lot shipped, that'd be sweet!!

[kevinod]

Hey Mike,

a quick suggestion - the pic for the narrow and wide meshes on the side are identical, would be handy to have a bigger pic to show the difference between them.

Oh ya - pm me if you guys can do Razo gear knobs...

[Dave]

Hey Mike,

a quick suggestion - the pic for the narrow and wide meshes on the side are identical, would be handy to have a bigger pic to show the difference between them.

Oh ya - pm me if you guys can do Razo gear knobs...

off topic here but Kev, i've a Razo you might be interested in, i've no inserts for it, i'll dig out a pic and PM you.

[Dave]

http://cgi.ebay.co.uk/RAZO-RAZO-JAPAN-R ... dZViewItem

[Hostile Performance]

It works out at 100Cms by 32.5Cms (allowing for some decent slack), i'll probably be going for the powertec 50MM cold air feed as well, so if you want to PM me a price for the lot shipped, that'd be sweet!!

Ok mate, I'll get back to you shortly.

a quick suggestion - the pic for the narrow and wide meshes on the side are identical, would be handy to have a bigger pic to show the difference between them.

Sounds like a sensible suggestion to me! - I'll get onto it.

Sorry, we don't do Razo at the moment (looks like you've found one though... )

[Myfeckin FTO]

now the question is, what mesh do i go for, i'm thinking black cos of the black bonnet, but there's two here on hostile performances site, narrow or wide!!

http://www.hostileperformance.co.uk/Pro ... tegory=570

any suggestions?

Has to be wide mesh in black for me - its too big a gap for silver coloured mesh. The cold air induction kit would be an nice addition.